1、未开始试验不要点击“启动” 试验按钮。
1. Do not click the "start" test button before starting the test.
2、每次进入程序时，若有异常提示或默认负荷值与以往不同时，不要进行试验，参照故障处理方法排除。测控系统每次刚进入试验界面时的负荷值均应是零点附近(不调零)。
2. When entering the program, if there is abnormal prompt or the default load value is different from that in the past, do not carry out the test, and refer to the troubleshooting method for troubleshooting. Each time the measurement and control system enters the test interface, the load value should be near the zero point (without zero adjustment).
3、卧式拉力试验机使用油缸复位键可以使油缸活塞上升或下降到设定的位置，当位移显示位置值大于设定位置时，点击油缸复位键时活塞就会下降;反之，活塞就会上升。注意经常关注活塞实际位置与位移显示位置是否一致，切忌油缸实际处于高位置时，盲目使用此键进行上升或下降。
3. The horizontal tensile testing machine can make the oil cylinder piston rise or fall to the set position by using the cylinder reset key. When the displacement display position value is greater than the set position, the piston will drop by clicking the cylinder reset key; otherwise, the piston will rise. Pay attention to whether the actual position of the piston is consistent with the displacement display position. Do not use this key blindly when the oil cylinder is in the high position.
4、拉力机夹紧试样后不要再对负荷值“调零”。
4. Do not "zero" the load value after clamping the sample by the tensile machine.
5、装夹引伸计，注意拔掉定位销后再调零;当摘下引伸计时，注意插上定位销，防止引伸计因人为过载而损坏。
5. When clamping the extensometer, pay attention to pull out the positioning pin and then adjust to zero; when taking off the extension timing, pay attention to inserting the positioning pin to prevent the extensometer from being damaged due to human overload.
6、卧式拉力试验机试样破断后，程序如果没退出试验状态并提示试验结束，须马上单击停止按钮退出试验状态。
6. If the program does not exit the test state and prompts the end of the test after the sample of horizontal tensile testing machine is broken, click the stop button immediately to exit the test state.
7、做完试验退出程序，钢丝拉力机应先用WINDOWS关机后方可切断电源;关闭油泵并使油缸落到底。
7. After the test exit procedure, the steel wire tensile machine should be shut down with windows before cutting off the power supply; turn off the oil pump and make the oil cylinder fall to the bottom.
8、计算机移动时注意插头不要松动。
8. Pay attention not to loosen the plug when the computer is moving.
The above wonderful content has Jinan test machine factory http://www.jnsd17.com Provide technical support, our website will continue to present a lot of new information for you, please remember to pay attention to us!
QQ客服